How to make modem to autoanswer Print
If the software that you are using with the modem does not have the ability to set the modem to autoanswer you will need to configure the modem manually. You will have to use Hyperterminal to enter the command into the modem's memory.
(if you do not have Hyperterminal installed please add it by going to Control Panel > Add/Remove Programs > Windows Setup > Communications > Details...)

Have the modem connected to your computer and ensure that it is working fine. Go to:
Start > Programs > Accessories > [Communications] > Hyperterminal .... Hyperterm.exe > name the connection "modem" > Connect Using... Select COM3 or COM4 (on whichever port the modem was assigned to) > Bits per second 9600 > OK.
After that try typing ATZ command and press ENTER (you may not see what you are typing). The response from the modem should be OK.
Apply the following command:

ATS0=3

Now write the new settings into the modem's memory by typing the following command and pressing Enter:

AT&W

The response should be "OK"
The modem will now be set to auto-answer after 3 rings.
How can we improve it?
Note:
We do not reply to these comments. However, we do read them and use your suggestions to improve our site. If you would like to receive a response to a question please go to the Contacts page and select the appropriate department to contact.